
Stationary GSM system
There are various fields of application for remote meter
reading via GSM (Global System for Mobile Communication).
One of these is remote reading of measurement points
installed in systems where effective reading via walkby
radio or M-bus is not an option.
Bulk consumer measuring points can also be read
easily and at short intervals via GSM. Other fields of
application are leak detection and pressure monitoring.
An alarm message is sent via SMS in the event
of an unusual operational status.
Long travel times and complicated access, for example
to meters integrated into shafts, often result in
huge effort being expended. This increases the more
often the meter has to be read.
Remote meter reading and measurement point monitoring via
GSM and internet
With ZENNER’s GSM solution these are problems of
the past, and an investment in our GSM system will
pay for itself in a very short time.
Up to two meters or pulse outputs are connected to
our GSM data logger GSM multilog for remote reading
via GSM. The battery-operated data logger has an integrated
GSM modem and stores the meter readings
at regular, freely configurable intervals. The data are
transmitted to a server via SMS. The highest level of
data security is guaranteed. Consumption data can
be retrieved and evaluated via a protected internet portal.
The data is therefore available for access at any time.
The same portal can be used to individually configure
the GSM multilog and for example set up alarm messages.